solaris86
dentro ci trovo una stringa con scritto cosa? e che devo mettere x dirgli di interlacciarlo?
thx!
Puoi modificare quel file aiutandoti con delle utility, come xf86config, oppure andare nella sezione riguardante il monitor (all'interno dello stesso file), che nel mio caso appare così:
Codice:
[...]
# **********************************************************************
# Monitor section
# **********************************************************************
# Any number of monitor sections may be present
Section "Monitor"
Identifier "My Monitor"
# HorizSync is in kHz unless units are specified.
# HorizSync may be a comma separated list of discrete values, or a
# comma separated list of ranges of values.
# NOTE: THE VALUES HERE ARE EXAMPLES ONLY. REFER TO YOUR MONITOR'S
# USER MANUAL FOR THE CORRECT NUMBERS.
HorizSync 30 - 70
# HorizSync 30-64 # multisync
# HorizSync 31.5, 35.2 # multiple fixed sync frequencies
# HorizSync 15-25, 30-50 # multiple ranges of sync frequencies
# VertRefresh is in Hz unless units are specified.
# VertRefresh may be a comma separated list of discrete values, or a
# comma separated list of ranges of values.
# NOTE: THE VALUES HERE ARE EXAMPLES ONLY. REFER TO YOUR MONITOR'S
# USER MANUAL FOR THE CORRECT NUMBERS.
VertRefresh 50-160
EndSection
[...]
Le righe precedute da # sono commenti e non vengono letti dal computer, servono solo agli utenti; tu dovresti impostare i valori adeguati al tuo monitor, non so se l'interlacciamento richieda impostazioni particolari però.