Utilizzando il programma HDD Death, per analizzare lo hard disk, mi da questo problema:
Your hard disk is a Maxtor 6L080L0 with firmware BAJ41G20.
The average temperature for this hard disk is 37C (MIN=26C MAX=47C) and yours is 38C.
Your hard disk's S.M.A.R.T. attributes are now being analyzed and a full report about the reliability, health and status of your hard disk is generated:
Your hard disk is not below any attribute threshold. This is good.
Your hard disk was never below any attribute threshold. This is good.
Your hard disk is now being compared to real data used to define normal values for your specific hard disk model. This way, the analysis can automatically use proper operating ranges. The images give you an idea of how each attribute is within such range. Current and raw values are shown for easier reference for experienced users. There are 1047 hard disk models in the current archive.
Attribute Current Raw OverallSpin Up Time2522180Very good
Start/Stop Count25320Very good
Reallocated Sector Count2530Very good
Read Channel Margin2530Very good
Seek Error Rate2530Very good
Seek Time Performance24149933WatchWarning: Seek Time Performance is below the average limits (242-250).
Power On Hours Count2539472Very good
Spin Retry Count2520Normal
Calibration Retry Count2530Very good
Power Cycle Count25351Very good
Power Off Retract Count2530Very good
Load Cycle Count2530Very good
Hardware ECC Recovered253687Very good
Reallocated Event Count2530Very good
Current Pending Sector2530Very good
Offline Uncorrectable Sector Count2530Very good
Ultra DMA CRC Error Rate2530Very good
Write Error Rate2530Very good
Soft Read Error Rate2530Very good
TA Increase Count2530Very good
Run Out Cancel2530Very good
Shock Count Write Opern2530Very good
Shock Rate Write Opern2530Very good
Spin High Current2520Normal
Spin Buzz2520Normal
Offline Seek Performance241150Normal
Unknown attribute 2102530Very good
Unknown attribute 2112530Very good
Unknown attribute 2122530Very good
NOTE: not all warnings are reflected on fitness and performance overall values as relevancy is based upon the settings from the hard disk manufacturer who is the best entity deputed to define such relationships.
The overall fitness for this drive is 88%.
The overall performance for this drive is 88%.
Da quando ho questo problema le percentuali del fitness e della performance si sono abbassate del 5%. Potete aiutarmi?
(p.s.: non posto tutte le immagini altrimenti mi da l'errore.)